Take Away Warning Does Not Operate

TAKE AWAY WARNING DOES NOT OPERATE


Diagnosis Procedure

1.CHECK POWER POSITION
Check if ignition switch position is changing or not.
Does ignition switch position change?
YES - GO TO 2.
NO - Check BCM for DTC. Refer to Testing and Inspection.
2.CHECK DOOR SWITCH
Check door switch. Refer to Component Function Check.
Is the inspection result normal?
YES - GO TO 3.
NO - Repair or replace the malfunctioning parts.
3.CHECK KEY SLOT
Check key slot. Refer to Component Function Check.
Is the inspection result normal?
YES - GO TO 4.
NO - Repair or replace the malfunctioning parts.
4.CHECK INSIDE KEY ANTENNA
Check inside key antenna.
- Instrument center: Refer to B2621.
- Console: Refer to B2622.
- Trunk room: Refer to B2623.
Is the inspection result normal?
YES - GO TO 5.
NO - Repair or replace the malfunctioning parts.
5.CHECK BUZZER (COMBINATION METER)
Check buzzer (combination meter). Refer to Component Function Check.
Is the inspection result normal?
YES - GO TO 6.
NO - Repair or replace the malfunctioning parts.
6.CHECK COMBINATION METER DISPLAY FUNCTION
Check combination meter display function. Refer to Component Function Check.
Is the inspection result normal?
YES - GO TO 7.
NO - Repair or replace the malfunctioning parts.
7.CHECK INTELLIGENT KEY WARNING BUZZER
Check Intelligent Key warning buzzer. Refer to Component Function Check.
Is the inspection result normal?
YES - GO TO 8.
NO - Repair or replace the malfunctioning parts.
8.CHECK KEY SLOT INDICATOR
Check key slot indicator. Refer to Component Function Check.
Is the inspection result normal?
YES - GO TO 9.
NO - Repair or replace the malfunctioning parts.
9.CONFIRM THE OPERATION
Confirm the operation again.
Is the result normal?
YES - Check intermittent incident. Refer to Intermittent Incident.
NO - GO TO 1.