Diagnosis Procedure

TILT SWITCH


Description

Tilt switch is equipped to the steering column. The operation signal is input to the automatic drive positioner control unit when the tilt switch is operated.




TILT SWITCH


Diagnosis Procedure

1.CHECK TILT SWITCH SIGNAL
1. Turn ignition switch OFF.
2. Disconnect tilt and telescopic switch connector.
3. Check voltage between tilt and telescopic switch harness connector and ground.





Is the inspection result normal?
YES - GO TO 3.
NO - GO TO 2.
2.CHECK TILT SWITCH CIRCUIT
1. Disconnect automatic drive positioner control unit connector.
2. Check continuity between automatic drive positioner control unit harness connector and tilt and telescopic switch harness connector.





3. Check continuity between automatic drive positioner control unit harness connector and ground.





Is the inspection result normal?
YES - Replace automatic drive positioner control unit. Refer to Automatic Drive Positioner Control Unit.
NO - Repair or replace harness.
3.CHECK TILT SWITCH
Refer to Component Inspection.
Is the inspection result normal?
YES - GO TO 4.
NO - Replace tilt and telescopic switch. Refer to Removal and Installation.
4.CHECK INTERMITTENT INCIDENT
Refer to Intermittent Incident.
- INSPECTION END