A/T - Fluid Level Inspection Procedure

Group AUTOMATIC TRANSAXLE

Number 09-AT-003

Date FEBRUARY, 2009

Model
2010~ GENESIS COUPE 2.0L TURBO

Subject
GENESIS COUPE 2.0L TURBO AUTOMATIC TRANSAXLE FLUID LEVEL

DESCRIPTION:

The Genesis Coupe 2.0L Turbo utilizes a new electronically controlled 5-speed automatic transaxle. The ATF level can be checked by the following procedure:

NOTE:
The Genesis Coupe 2.0L uses synthetic automatic transaxle fluid (ATF). Use only ATF meeting the Red Line specification approved by Hyundai Motor Company. DO NOT use SPIII or other ATF which may result in degradation of shift quality or transaxle durability.

ATF LEVEL INSPECTION:





1. Attach a GDS and select vehicle and "A/T" menu.





2. Select Current Data and "Fluid temperature-1 (Oil Pan)". Drive the vehicle until the fluid temperature is between 122~140°F (50~60°C).





3. Step on the brake and then shift into "R", "N", "D" and back, pausing 2 seconds in each range. Shift into Sports Mode 1 & 2. Repeat two times.

4. Move the shift lever to P, leave the engine running and lift the vehicle on a hoist.





5. Remove the fill and overflow plug. The oil level is correct if ATF flows out in a thin oil stream or steady drop-by-drop. If no oil flow occurs, go to Step 6.

NOTE:
Collect and dispose of any excess fluid in accordance with local regulations.

6. Add ATF to the fill plug hole in 1/4 quart increments until ATF flows out of the fill plug hole in a thin oil stream or steady drop-by-drop.

NOTE:
DO NOT use SPIII or other ATF.

NOTE:
Use a fluid transfer pump to add ATF (Use the following products or equivalent).

^ MAC Tools Fluid Dispenser #MV7201 or #GS19HD

^ Snap-on Suction Gun #YA745A

7. Reinstall the fill plug with a new gasket and tighten to specification:

^ Fill plug: 25~33 lb-ft (3.5~5.0 kgf.m)





PARTS INFORMATION





MAINTENANCE SCHEDULE