Repair Procedures

Inspection

1. Disconnect the back up lamp switch connector.
2. Check the continuity between no. 1 and 2 terminals of backup lamp switch.
When the shift lever is in reverse, there should be continuity.
3. If necessary, repair or replace the backup lamp switch.






Replacement

1. Disconnect the back up lamp switch connector.
2. Remove the connector bracket (B) by removing the hinge bolt (A).

Tightening torque :
55 - 69 Nm (5.5 - 6.9 kgf.m, 39.8 - 49.9 lb-ft)




3. Remove the back up lamp switch (C) with gasket.
4. Replace a new one with a new gasket and install the back up lamp switch.

Tightening torque :
30 - 35 Nm (3.0 - 3.5 kgf.m, 21.7 - 25.3 lb-ft)

5. Install the removed parts in reverse order of removal.

CAUTION:
Be sure to use a new gasket.