Rear Door Window Glass: Service and Repair

Replacement

Glass Replacement

1. Remove the rear door trim.
2. After loosening the mounting screws, then remove the rear door seal (A).

NOTE:
- Replace any damaged door seal.




3. Remove the rear door belt inside weatherstrip (A).




4. Remove the rear door belt outside weatherstrip (A).

NOTE:
- Rear door belt outside weatherstrip is need to changed to new product surely.




5. After loosening the mounting screws, then remove the rear door delta moulding (A).




6. Loosen the rear door channel mounting nuts.

Tightening torque :
3.9 - 5.9 N.m (0.4 - 0.6 kgf.m, 2.9 - 4.3 lb-ft)




7. Carefully adjust the glass (A) until you can see the screws, then loosen them. Separate the glass from the glass run and carefully pull the glass out through the window slot.

Tightening torque :
3.9 - 5.9 N.m (0.4 - 0.6 kgf.m, 2.9 - 4.3 lb-ft)




8. Installation is the reverse of removal.

NOTE:
- Roll the glass up and down to see if it move freely without binding.
- Adjust glass position as needed.