Tail Lamp: Service and Repair

Removal

1. Disconnect the negative (-) battery terminal.
2. Remove the trunk lower trim.

3. Disconnect the rear combination lamp connector (A). Remove the rear combination lamp assembly (B) after loosening 3 nuts.








4. Remove the bulb after turning in the counterclockwise direction.
A : Tail Lamp / Stop Lamp
B : Turn Signal Lamp
C : Back Up Lamp
D : Side marker




5. If necessary to remove the bulb, remove the bulb after pulling the trim cover aside.

[Tail Lamp / Stop Lamp]





[Turn Signal Lamp]





[Back up Lamp]





[Side marker]






Installation

1. Install the rear combination lamp assembly.
2. Connect the rear combination lamp assembly connector.
3. Connect the negative (-) battery terminal.