Power Door Lock Actuator: Testing and Inspection

Inspection

Front Door Lock Actuator Inspection
1. Remove the front door trim.

2. Remove the front door latch.
3. Disconnect the 5P connector from the actuator.




4. Check actuator operation by connecting power and ground according to the table. To prevent damage to the actuator, apply battery voltage only momentarily.





Rear Door Lock Actuator Inspection
1. Remove the rear door trim.

2. Remove the rear door latch.
3. Disconnect the 5P connector from the actuator.




4. Check actuator operation by connecting power and ground according to the table. To prevent damage to the actuator, apply battery voltage only momentarily.





Front Door Lock Switch Inspection
1. Remove the front door trim panel.

2. Remove the front door latch.
3. Disconnect the 5P connector from the actuator.




4. Check for continuity between the terminals in each switch position when inserting the key into the door according to the table.





Rear Door Lock Switch Inspection
1. Remove the rear door trim panel.

2. Remove the rear door latch.
3. Disconnect the 5P connector from the actuator.




4. Check for continuity between the terminals in each switch position according to the table.