Repair procedures

Removal

1. Disconnect the battery negative cable, and wait for at least three minutes before beginning work.
2. Remove the front passenger seat assembly.
3. Remove the seat cushion as an assembly.

Installation

1. Install the PODS equipped seat front assembly.
2. Reconnect the battery negative cable.
3. After installing the PODS, confirm proper system operation :
A. Turn the ignition switch ON; the SRS indicator should be turned on for about six seconds and then go off.
Telltale lamp will turn on for 4 seconds and be turned off for 4 seconds. After the 8 seconds, it shall remain off if the PODS does not require suppression and the passenger airbag is enabled.

NOTE:
Be sure to perform PODS reset with scantool after replacing PODS equipped seat cushion.