Engine Control Module: Service and Repair

Removal

NOTE:
In the case of the vehicle equipped with immobilizer, perform "Key Teaching" procedure together .

1. Turn ignition switch OFF and disconnect the negative (-) battery cable.
2. Remove the front strut assembly .
3. Disconnect the ECM Connector (A).




4. Disconnect the TCM connector (B) [A/T].
5. Remove the ECM bracket installation bolts (C) and nut (D).

Installation

NOTE:
In the case of the vehicle equipped with immobilizer, perform "Key Teaching" procedure together .

1. Installation is reverse of removal.

ECM bracket installation bolt/nut:
9.8 - 11.8 N.m (1.0 - 1.2 kgf.m, 7.2 - 8.7 lb-ft)