Repair procedures

Replacement

1. Disconnect the back up lamp switch connector.
2. Remove the connector bracket (B) by removing the hinge bolt (A).

Tightening torque :
55 - 69 Nm (5.5 - 6.9 kgf.m, 39.8 - 49.9 lb-ft)




3. Remove the back up lamp switch (C) with gasket.
4. Replace a new one with a new gasket and install the back up lamp switch.

Tightening torque :
30 - 35 Nm (3.0 - 3.5 kgf.m, 21.7 - 25.3 lb-ft)

5. Install the removed parts in reverse order of removal.

CAUTION:
Be sure to use a new gasket.