Transaxle Gear Oil Level Replacement

Service Adjustment Procedure

Replacement
1. With the vehicle parked on a level surface, remove the drain plug.
2. Drain the transaxle oil after loosening the drain plug(A).




3. Install the drain plug with new washer.

Drain plug tightening torque:
60 - 80 Nm (6.0 - 8.0 kgf.m, 43.4 - 57.9 lb-ft)


4. Add new oil through the fill plug hole and, fill it just below the plug opening.

Standard oil SAE 75W/85, API GL-4
Oil capacity:2.0 liter (2.1 US qt, 1.76 lmp qt)


Backup Lamp Switch

Inspection
1. Disconnect the backup lamp switch(A).




2. Check the continuity between no. 1 and 2 terminals of backup lamp switch.
When the shift lever is in reverse, there should be continuity




3. If necessary, repair or replace the backup lamp switch.