Component Inspection

Component Inspection

1. Set up an oscilloscope as follows :
Channel A (+): terminal 2 of the CKPS (back probe), (-): ground
Channel B (+): terminal 2 of the CMPS (back probe), (-): ground
2. Start the engine and check for signal waveform compared with reference waveform as below.








Fig.1) The square wave signal should be smooth and without any distortion.
Fig.2,3) The CMPS falling (rising) edge is coincided with 3rd ~ 5th tooth of the CKP from one longer signal (missing tooth)
3. Is the signal waveform normal ?