Transmission Removal

AUTOMATIC TRANSAXLE





COMPONENTS

REMOVAL





1. Remove the engine cover.





2. Remove the battery terminal.





3. Remove the air duct.





4. Remove the battery tray.
5. Remove the air cleaner.





1. Upper





2. Lower





6. After removing the CKP sensor, O2 sensor and oil pressure switch wiring bracket, separate the connectors.
7. Remove the speedometer sensor connector.





8. Remove the transaxle range switch.





9. Remove the oil cooler hose.





10. Remove the clip-transaxle side) of the shift cable.





11. Separate the steering column shaft joint.





12. Separate the power steering oil pump hose.

NOTE: Be careful not to leak after separating.





13. Separate the hose after removing the clip of the power steering return hose.





14. Remove the upper connecting transaxle bolt.





15. Separate the start motor.
16. Install the engine support fixture.





17. After removing the tire, remove the caliper.





18. Remove the transaxle side cover.





19. Remove the transaxle under cover.





20. Separate the tie rod end.





21. Remove the wheel speed sensor and the knuckle mounting bolt.





22. Drain the oil.
23. Remove the transaxle mounting bracket.





1. Insulator bolt





2. Body mounting bolt (Upper)





3. Body mounting bolt (Side)





4. Transaxle side mounting bolt
24. Remove the front roll stopper.





1. Insulator bolt





2. Stopper bolt (Upper)





3. Stopper bolt (Lower)
25. Remove the rear roll stopper.





1. Insulator bolt





2. Stopper bolt
26. Remove the drive shaft.





27. Remove the front muffler.





28. Remove the sub frame mounting bolt.





29. Install the jack under the transaxle assembly.





30. Remove the transaxle lower mounting bolt to the engine.
31. Remove the transaxle assembly.