Side Impact Sensor (SIS)

SIDE IMPACT SENSOR (SIS)

REMOVAL

CAUTION:
- Removal of the airbag must be performed according to the precautions/procedures described previously.
- Before disconnecting the side impact sensor connector(s), disconnect the side airbag connector(s).
- Do not turn the ignition switch ON and do not connect the battery cable while replacing the side impact sensor.

1. Disconnect the battery negative cable, and wait for at least three minutes before beginning work.
2. Remove the front seat.
3. Remove the door scuff trim and center pillar trim.
4. Remove the floor carpet.
5. Disconnect the Side Impact Sensor connector.







6. Remove the SIS mounting bolt then remove the Side Impact Sensor.

INSTALLATION

CAUTION: Do not turn the ignition switch ON and do not connect the battery cable while replacing the side impact sensor.

1. Install the new Side Impact Sensor with the bolt then connect the SRS harness connector to the Side Impact Sensor.

Tightening torque :
[ADVANCED] 0.7 - 1.3 kgf.m (7 - 13 N.m, 5.2 - 9.6 lb.ft)
[DEPOWERED] 0.6 - 0.8 kgf.m (6 - 8 N.m, 4.4 - 5.9 lb.ft)

2. Install the following parts.
- Door scuff trim, Center pillar trim

3. Reconnect the negative battery cable.
4. After installing the Side Impact Sensor, confirm proper system operation: Turn the ignition switch ON, the SRS indicator light should be turned on for about six seconds and then go off.