Passenger Side Replacement

PASSENGER AIRBAG REPLACEMENT

REMOVAL
1. Disconnect the battery negative cable and wait at least three minutes before beginning work.




2. Remove the glove box then disconnect the connector between the SRS main harness 4P connector (A) and front passenger's airbag 4P connector (B).
3. Remove the dashboard.




4. Remove the mounting nuts (A) from the dashboard. Then remove the passenger's airbag.

INSTALLATION
1. Place the new front passenger's airbag on the dashboard. Tighten the front passenger's airbag mounting nuts.
2. Install the dashboard.
3. Connect the front passenger's airbag 4P connector to the SRS main harness 4P connector.
Attach the front passenger's airbag connector to the connector holder, then reinstall the glove box.
4. Reconnect the battery negative cable.
5. After installing the airbag, confirm proper system operation : Turn the ignition switch On; the SRS indicator light should blink for about six seconds and then go off.
6. Enter the customer's preset radio stations.