Shifter A/T: Service and Repair

AUTOMATIC TRANSAXLE SHIFT CONTROL
REMOVAL





1. Remove the push button, the spring and the cap.





2. Remove the knob mounting nut.





3. Remove the shift knob.
4. Remove the console upper cover.





5. Remove the console assembly.





6. Remove the indicator panel.





7. Remove the indicator lower cover.





8. Remove the indicator plate.





9. Remove the key lock cable nut.





10. Remove the shift lock cable nut.





11. Remove the control cable snap pin.





12. Remove the control cable clip and the control cable.





13. Remove the shift lever bracket bolt.





14. Remove the shift lever.

INSTALLATION





PROCEDURE TO INSTALL THE LOCK CAM





1. Move A/T lever to "P" position to set the key lock cam and the shift lock cam as shown in the figure.
1) Check that the key lock cam is located at "B" by the detent pin.
2) Check that the shift lock cam is located at "A".
2. Check that the key cylinder is at "LOCK".

PROCEDURE FOR ADJUSTING SHIFT LOCK AND KEY LOCK CABLE
1. Check that each lock cam is as shown in the figure.
2. Install the shift lock and key lock cable in position. In this case, the shift lock cable must be fixed to the brake pedal and the key lock cable must be fixed to the key cylinder.





3. Temporarily install each cable to the A/T lever assembly as shown in the figure. Securely insert the cable end into the fixing pin of each cam.
4. Slightly pull the shift lock cable in the direction "E".
5. After checking that the portion of the cable end touches the cable fixing pin, fix with the self-tapping bolt.
6. Slightly push the key lock cam to direction "Q".
7. Slightly pull the key lock cable in the direction "G" to stretch the cable. Then fix the cable with the self tapping bolt.





8. Check that the key lock and the shift lock cable are secure.

PROCEDURE FOR CHECKING THE SHIFT LOCK
1. When the brake pedal is not depressed, the push button of the shift lever at UP" position must not be operable. (Shift lever cannot be shifted at the other positions from "P".)
2. When the brake pedal stroke is 15 - 22 mm (with shift lever at "P" position), the push button should be operable without catching and the shift lever should shift smoothly to other positions.
3. When the brake pedal is not depressed, the shift lever should shift smoothly to UP" position from all heading other positions.
4. The brake pedal must operate smoothly without catching.
5. When the ignition key is at the "LOCK" position, although rake pedal is depressed, the push button should be operable.
6. The Ignition key must not be able to be turned to the "LOCK" position except in the "P" position.
7. If the shift lever is shifted to the UP" position, the ignition key must turn to the "LOCK" position smoothly.