Ignition Switch: Service and Repair

REMOVAL AND INSTALLATION
1. Disconnect the negative battery terminal.
2. Remove the air bag module.

CAUTION: The SRS system is designed to retain enough power to deploy air bag for about 30 seconds even after battery has been disconnected, so deployment it service is done on the SRS system immediately after battery cable is disconnected.

3. Loosen the tapping screw and lift up horn pad and remove it.
4. Remove the lock nut and the washer.




5. Pulling the dynamic damper forward, lift it up and remove it.
6. Install the special tool (09561-11001) and remove the steering wheel.

CAUTION: Do not hammer on the steering wheel to remove it.




7. Remove the steering column lower and upper shrouds.




8. Remove the lower cover.




9. Disconnect the connectors and remove the multifunction switch.




10. Remove the mounting bolts and separate ignition switch from steering column.