Passenger's Side Door Wiring Connector & Door Wiring Repl.

NOTE:
This procedure applies to an excessively corroded passenger's side door wiring connector. This section will refer to the individual steps that have been covered in earlier sections.

1. Lay down a protective covering over the passenger side carpeting. Perform the same steps to solder the wiring connector kit to the vehicle wire as performed in steps 1 through 8 in the "Driver's Side Door Wiring Connector and Door Wiring Replacement" section.








2. Replace the passenger front door wire harness. Follow the procedure in steps 9 through 18 in the "Driver's Side Door Wiring Connector and Door Wiring Replacement" section. Use the following part numbers to select the correct passenger front door wire harness.

3. Insert the door wire harness connector back into the body hole. Follow the procedure in steps 19 and 21 in the "Driver's Side Wiring Connector and Door Wiring Replacement" section.

4. Connect the connectors.

5. Finish the repair by following steps 12 through 19 in the "Passenger's Side Door Wiring Connector Inspection" section to reassemble the vehicle.