Manual Update Procedure

NOTE
In the event menu option "01. LC 00-02MY COLD STUMBLE [AUTO]" fails to download the new ECM program, option "02. LC 00-02MY COLD STUMBLE [ERROR]" must be used.

1. Turn the ignition to the ON position.

2. Turn the Hi-Scan Pro ON and press ENTER.





3. Select menu option "31. LC 00~02MY COLD STUMBLE&02MY P0116" and press ENTER.





4. Select menu option "02. LC 00~02MY COLD STUMBLE [ERROR]" for manual update and press ENTER.





5. Choose the correct specification for your vehicle by identifying the VIN and engine and by referring to the "ECM SPECIFICATION TABLE" in this bulletin to choose one of6 choices. Then press ENTER.





NOTE
If the vehicle is equipped with ECM 39110-22550, use option 01. for 39110-22551.

NOTE
If the vehicle is equipped with ECM 39110-22560, use option 02. for 39110-22561.

6. Select the correct password for Manual Update from the "ECM SPECIFICATION TABLE" in this bulletin.

^ Enter the correct password and press ENTER





WARNING
If an incorrect password is used, the correct ECM software will not be downloaded.

7. Wait until the reprogramming is completed. The Hi-Scan Pro will reprogram the ECM.

NOTE
Once the password is entered and accepted, the rest of the procedure is exactly the same as the automatic update procedure.





8. Compare the new ECM ID displayed on the Hi-Scan Pro screen with the one that's listed as the correct new ECM ID in the table in this TSB, to make sure that the correct software has been installed.

9. When the COMPLETED message is displayed, turn the Hi-Scan Pro OFF and the process is complete.





NOTE
When reprogramming has been completed successfully, turn the ignition to the OFF position for 20 seconds and then start the engine to check for proper operation.