Flywheel and Drive Plate

M/T: Manual Transaxle Vehicles
A/T: Automatic Transaxle Vehicles

REMOVAL
1. Remove the transaxle and clutch.
2. Remove the flywheel.

INSPECTION
1. Check the clutch disc contacting surface of the flywheel for damage and wear. Replace the flywheel if excessively damaged or worn.
2. Check the clutch disc contacting surface of the flywheel for runout.
Standard value
Flywheel run-out 0.1 mm (0.004 inch)
3. Check the ring gear for damage, cracks and wear, and replace if necessary.

INSTALLATION
Install the flywheel assembly and tighten the bolts to the specified torque.
Tightening torque
Flywheel bolt 120 - 130 Nm (1200 - 130 kg.cm, 88 - 96 ft. lbs.)