Front Bumper: Service and Repair
FRONT BUMPERFront Bumper:
REMOVAL AND INSTALLATION
1. Remove the turn signal lamp.
2. Remove the front bumper cover mounting retainer.
3. Remove the front bumper upper side mounting nut.
Tightening torque 4-6 N.m (40-60 kg.cm, 2.88-4.32 lb.ft)
4. Remove the mounting bolt in the corner of front bumper.
Tightening torque 4-6 N.m (40-60 kg.cm, 2.88-4.32 lb.ft)
5. Disconnect the fog lamp connector and remove the front bumper beam stay mounting bolts.
Bumper beam stay mounting bolt
Tightening torque 20-23 N.m (200-230 kg.cm, 14-17 lb.ft)
6. Installation is the reverse of removal.