Driver Airbag Module and Clockspring

Driver Air Bag Module and Clock Spring
1. Disconnect the negative battery cable and keep secure from battery.

CAUTION: Wait at least 30 seconds after disconnecting the battery cable before doing any further work.

2. Remove the side protect cover of steering wheel and airbag module mounting bolts.

3. When disconnecting the connector of the clock spring from the airbag module, pull the airbag's lock toward the outer side to spread it open.

CAUTION:
- When disconnecting the airbag module-clock spring connector, take care not to apply excessive force to it.
- The removed airbag module should be stored in a clean, dry place with the pad cover face up.

4. Remove the steering wheel lock nut.

CAUTION: Do not hammer on the steering wheel. Doing so may damage the collapsible column mechanism.

5. After making alignment marks on the steering shaft and wheel remove the steering wheel using the steering wheel puller.

6. Installation is the reverse of removal.
When installing the airbag module to steering wheel check fit and align the clock spring with the wheel.