Campaign - Tire Inflation Label Replacement

Group
CAMPAIGN

Number
99-01-001

Date
APRIL, 1999

Model
1999 TIBURON

Subject
1999 TIBURON TIRE INFLATION PRESSURE LABEL REPLACEMENT PROCEDURE
CAMPAIGN (32)

DESCRIPTION:

Some Tiburon vehicles produced between 12/8/98 and 3/8/99 contain misprinted tire inflation pressure labels. This TSB provides a procedure for label replacement.

PROCEDURE:





1. Locate the original tire inflation pressure label at the lower edge of the driver side B-pillar. (see sketch)





2. Check to confirm that the correct label is attached to the driver side B-pillar. The label should contain a "Vehicle Capacity Weight. LBS: 700" and a "Seating Capacity: Total 4 Front 2 Rear 2". (see example)





3. If the label does not contain the correct values, carefully remove it from the driver side B-pillar. Remove it by peeling the label from a top corner, pulling it downward at an angle toward the other side. Pull with the label folded back 180° on itself. (see sketch below)

4. Clean any adhesive remaining on the surface using a rag dampened with rubbing alcohol to soften the adhesive. Then remove the loosened adhesive with a dry paper towel. Repeat these steps until the adhesive is completely removed.

5. Apply a new tire inflation pressure label in the same location.





PARTS INFORMATION





WARRANTY INFORMATION

SUBMIT CLAIMS FOR THE ABOVE CAMPAIGN OPERATION CODE USING THE CAMPAIGN CLAIM SCREEN.