P0336

FAILURE CONDITION
The ECM will set P0336 and the MIL will turn on immediately if the CKP sensor signal does not indicate the two missing teeth in exactly the same position on the tone wheel during two successive engine revolutions. This check is made for 5 seconds when the engine is running above 2000 rpm. this code indicates a problem with the crankshaft being read by the CKP sensor or ECM.





TEST PROCEDURE






TROUBLESHOOTING PROCEDURES

TROUBLESHOOTING HINTS
1. If unexpected misses are felt during driving or the engine stalls suddenly, shake the crankshaft position sensor harness. If this causes the engine to stall, check for poor contact at the sensor connector.
2. It the tachometer reads 0 rpm when the engine is cranked, check for faulty crankshaft position sensor or ignition system problems.
3. If the tachometer reads 0 rpm when the engine is cranked and it does not start, ignition coil, power TR, or an ECM defect can be considered.
4. Engine can be stalled when the crankshaft position sensor cable is close to the high voltage cable due to the electronic noise caused by the high voltage induced.