Rear

DISASSEMBLY





1. Before removing the piston rod tightening nut, compress the coil spring using the Special Service Tool (SST).

CAUTION: Do not use an air tool to tighten the bolt of the special tool.





2. While holding the piston rod, remove the piston rod tightening nut.

NOTE: after removing the strut, check it for the following.

- Check the rubber parts for damage.

- Check the coil springs for damage or deterioration.


ASSEMBLY
1. Compress the coil spring using the special toot and insert in the rear strut.





2. Align the edge of the coil spring to the position of the rear strut spring seat as shown.

NOTE: When replacing a coil spring, be sure to use a spring having the appropriate identification mark.





3. With the position of the bracket assembly as shown in the illustration, tighten the tightening nut according to the specified torque.