Installation

INSTALLATION






1. Apply a coating of the specified grease to the interior of the adjust bushing.

Specified grease:
Chassis grease SAE J310, NLGI No.0






2. Move the shift lever and the transaxle range switch to the "N" position, and install the transaxle control cable.






3. When connecting the control cable to the transaxle mounting bracket, install the clip until it contacts the control cable, in position switch in the figure.






4. Install the bolt-washer assembly, nut.






5. Install the clip pin, self lock pin
(shift lever side)






6. Connect the position indicator light connector, the O/D switch connector, the parking position switch connector, normal/economy select switch connector and the shift lock solenoid connector.
7. Install the shift lever indicator assembly.





8. Apply the specified grease at the places shown in the figure.

Specified grease:
Multipurpose grease SAE J310 NLGI No.2





9. Place the shift lever in the "N" position, and then turn the cam rod adjusting so that the clearance between the sleeve and the lever assembly end is within the standard value.

Standard value (A):
15.2-15.9 mm (0.598-0.625 in.)

10. Install the selector knob.
11. Install the console box.