Disassemble

Before disassembly, scribe alignment marks on fixtures and suspension arms to ensure components are assembled in same position. On models with stabilizer bar, scribe alignment marks on bar and stabilizer bracket.
1. Remove stabilizer bar from brackets, if equipped.

Fig. 2 Exploded View Of Rear Axle & Suspension:

2. Remove nuts on both ends of suspension arms, then remove washers, fixtures and rubber bushings, Fig. 2.
3. Remove dust cover clamp, then separate suspension into right and left arms. Leave dust cover attached to right suspension arm to protect lip from damage during disassembly.
4. Remove rubber stopper, then using screwdriver, remove bushing "A" from left suspension arm, Fig. 2.
5. Using hammer and suitable drift, drive bushing "B" from left suspension arm.
6. Inspect all components for excessive wear or damage, replacing parts as necessary.