Scan Tool Software - Update Information: Overview
Group: SPECIAL SERVICE TOOLSNumber: 98-09-004
Date: APRIL, 1998
Model: ALL
Subject
SCAN TOOL SOFTWARE UPDATE INFORMATION (VERSION 1.8)
DESCRIPTION:
This TSB describes the 1998 Scan Tool Software Package (V1.8) along with the following additional information to assist with Scan Tool operation:
^ Helpful Notes and Tips for Scan Tool "No Communication"
^ Using the Evaporative Emission System Trigger Test
^ Scan Tool part numbers
^ Scan Tool warranty labor operation codes
1998 SCAN TOOL SOFTWARE UPDATE (V1.8):
The new 1998 Scan Tool software update contains the following improvements and additions:
^ 1998 vehicle database
^ Evap system trigger for 1997 vehicles for use with Hyundai Diagnostic System (HDS) (this will save the Technician from waiting for the 15 minute pre-cycle time). See this TSB for complete instructions.
^ Updated diagnostic code (DTC) descriptions for easier understanding.
^ Data display uses "Custom Data" menu only. (Encourages Technician to select only the relevant component data to be displayed, resulting in improved data refresh rates.)
^ Removed "Connect OBDII Connector..." message for faster performance.
^ Improved accuracy of data readings.
^ Checks for proper GCI chip. (The GC1 chip is the other chip on the cartridge circuit board that must be at version 1.1. Communication errors would occur if the proper GC1 chip is not installed.)
NOTES AND TIPS FOR USING THE SCAN TOOL:
A. If a "No Communication" message is displayed on the HDS Scan Tool when trying to view codes or data, check/try the following items:
^ Check for correct Vehicle Identification Number (VIN). Be careful when entering a 1997 or 1998 VIN and answer the "Tiburon?" question correctly,
^ Clean the contacts of the K5A Personality Key with Hyundai Multi-Purpose Cleaner & Degreaser or another suitable contact cleaner, A film or residue from the shop environment may form on the Personality Key contacts causing poor circuit connection. Results may be erratic communication or no communication at all.
Note:
Many SRS system communication conditions are solved by cleaning the K5A Personality Key. However, if cleaning the K5A Personality Key contacts does not work, a replacement key may be necessary. Call Kent-Moore at 1-800-345-2233 to order a new K5A key (P/N J-41490-K5A).
^ SRS communication conditions can occur when the main SRS fuse is blown. The SRS light may be on, however, the module does not have power and cannot communicate with the Scan Tool.
^ Secure data link connection - Check OBD-II adapter and vehicle data link connector pins for damage. (Tweaking of OBD-II adapter pins approximately 10 degrees may help.)
^ Turn the ignition key OFF and back ON. This re-sets the Powertrain Control Module (PCM) communication system.
^ In some cases, for older model vehicles (pre-1996), it may be necessary to attempt communication by selecting one year above or one year below the model year being worked on as the software in the Scan Tool can only accommodate one communication setting per model configuration.
^ Re-enter the VIN and make sure the key is in the ON position and not the ACC position.
B. Codes should only be cleared with the ignition in the ON position. If the engine is running, the codes may not be cleared properly.
C. If the plastic cartridge housing is cracked or damaged, an empty replacement plastic cartridge (P/N J-41490-16) (includes the label) can be ordered through Kent-Moore. (See this TSB for more information and Scan Tool part numbers.)
D. A new Scan Tool adapter is available that contains an extra plastic strip to allow a more secure connection to the data link connector.