Throttle Cable/Linkage: Service and Repair

Accelerator Pedal And Cable:

REMOVAL OF ACCELERATOR CABLE

Accelerator Cable, Throttle End:

1. Loosen the accelerator cable adjusting nut.

Accelerator Cable, Pedal End:

2. Disconnect the accelerator cable from the accelerator arm.
3. Remove the accelerator cable.

REMOVAL OF ACCELERATOR PEDAL

Accelerator Return Spring And Cotter Pin:

1. CLoosen the accelerator cable adjusting nut, and disconnect the accelerator cable from the accelerator arm, remove the accelerator pedal.
2. Remove the return spring from the accelerator arm.
3. Remove the cotter pin from the accelerator arm shaft, then remove the accelerator arm from the accelerator arm bracket.

INSPECTION
1. Check the inner and outer cables for damage.
2. Check the cable for smooth movement.
3. Check the accelerator arm is not bent.
4. Check the return spring for deterioration.
5. Check for connection of accelerator cable to end fitting.

INSTALLATION

Accelerator Grease Point:

1. Apply multi-purpose grease around each moving point of the pedal assembly.
2. To prevent entry of exhaust fumes, apply semi-drying type sealant the bolt mounting hole, and then tighten the accelerator arm bracket bolts.
3. Make sure that the accelerator cable is routed without sharp bends or kinks.
4. Inspect the free play of accelerator cable (refer to ADJUSTMENT PROCEDURES).