Headlamp Switch: Service and Repair

Fig. 6 Multi-Function switch retaining screw location:

The lighting, dimmer, turn signal/hazard and wiper/washer switches are all incorporated into the multi-function switch assembly.
1. Disconnect battery ground cable.
2. Remove horn button cover, scribe alignment marks on steering wheel and shaft, then remove steering wheel using suitable puller.
3. Remove steering column trim shroud attaching screws, then the trim shrouds.
4. Remove switch retaining screws, Fig. 6, disconnect switch harness connector, then pull switch assembly from steering column.
5. Reverse procedure to install.