Completing the Procedures

35. Before closing the hood, you'll need to place a punch mark over the 1St digit on the firewall identification plate. This will show that the campaign procedures have been completed.





36. You will also need to apply an Authorized Modifications Label to the underside of the hood, close to the emissions label. This label will show the new ignition timing specification. Wipe the surface clean before applying the new label.





37. On the Authorized Modifications Label, you will need to write in the following information:

CHANGE AUTHORITY: 004

DEALER CODE: Your dealer code

REPAIR DATE: The date of the repair

Remove the backing from the clear adhesive on the front of the label and press down over the label.

38. After completing these procedures, make sure that all fuel and coolant connections are not leaking. Check that all fasteners are tightened to the proper torque and the choke shim is in position. Remove the fender covers.

NOTICE
The following statement must appear on the customers copy of the Repair Order as proof to the Department, of Motor Vehicles (DMV) that the campaign has been performed:

"Service Campaign 004 has been completed on this vehicle".