Accelerator Pedal Position Sensor: Service and Repair

Accelerator Pedal Position Sensor Replacement

Removal Procedure




1. Remove the knee bolster bracket. Refer to Driver Knee Bolster Bracket Replacement (Right Hand Drive) (Service and Repair)Driver Knee Bolster Bracket Replacement (Left Hand Drive) (Driver Knee Bolster Bracket Replacement).
2. Disconnect the accelerator pedal position (APP) sensor electrical connector.




3. Remove the accelerator pedal/APP sensor nuts.
4. Remove the accelerator pedal/APP sensor from the vehicle.

Installation Procedure




1. Install the accelerator pedal/APP sensor over the studs.

Caution: Refer to Fastener Caution (Fastener Caution).

2. Install the accelerator pedal/APP sensor nuts.

Tighten the nuts to 9 Nm (80 lb in).




3. Connect the APP sensor electrical connector.
4. Inspect below the pedal for binding, to ensure full range of motion.
5. Install the knee bolster bracket. Refer to Driver Knee Bolster Bracket Replacement (Right Hand Drive) (Service and Repair)Driver Knee Bolster Bracket Replacement (Left Hand Drive) (Driver Knee Bolster Bracket Replacement).