Data Communications

DTC C0550

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (Diagnostic System Check - Vehicle) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (Strategy Based Diagnosis) for an overview of the diagnostic approach.
* Diagnostic Procedure Instructions (Diagnostic Procedure Instructions) provides an overview of each diagnostic category.

DTC Descriptor
DTC C0550
- Electronic Control Unit (ECU) Performance

Circuit/System Description

The electronic brake control module (EBCM) detects an internal malfunction.

Conditions for Running the DTC

The ignition switch is in the ON position.

Conditions for Setting the DTC

An internal EBCM malfunction exists.

Action Taken When the DTC Sets

One or more of the following actions may occur:

* The EBCM disables the Antilock Brake System (ABS)/Traction Control System (TCS)/Vehicle Stability Enhancement System (VSES) for the duration of the ignition cycle.
* The dynamic rear proportioning (DRP) may be disabled and the Brake Warning indicator may turn ON.
* The Stability Caution indicator turns ON.
* The DIC displays the SERVICE STAB SYS message.
* The DIC displays the TRACTION FAILED message.

Conditions for Clearing the MIL/DTC

* The condition for the DTC is no longer present and the DTC is cleared with a scan tool.
* The EBCM automatically clears the history DTC when a current DTC is not detected in 100 consecutive drive cycles.

Circuit/System Verification

Important: It is recommend that the defective components be replaced, and not the complete brake master cylinder assembly.


DTC C0550 will set as result of internal EBCM circuit failure.


Replace the EBCM.

Repair Instructions

Perform the Diagnostic Repair Verification (Verification Tests) after completing the diagnostic procedure.

Control Module References (Programming and Relearning) for EBCM replacement, setup, and programming