Roof Clearance Lamp Bulb Replacement

Roof Clearance Lamp Bulb Replacement

Removal Procedure





1. Remove the air inlet cover (1) by pulling up to release the clips.
2. Open the front doors.
3. Remove A-pillar trim by first peeling back the weatherstrip to expose the 2 screws.
4. Use a Phillips head screwdriver, to remove the screws.
5. Pull up on the lower end of the A-pillar trim to unsnap the clips (1).
6. Unhook the A-pillars from the front end of the luggage rack/siderail.
7. Remove bulb socket from the lamp assembly by rotating 1/4 turn counterclockwise.
8. Pull the bulb out of the socket.
9. Replace the bulb.



Installation Procedure

1. Install the lamp socket into the lamp assembly by rotating the lamp socket 1/4 turn clockwise.




2. Install the A-pillar trim by hooking the rear edge under the tab (2) at the luggage rack/siderail and pressing the clips (1) into place.

Notice: Refer to Fastener Notice (Fastener Notice) .

3. Install the 2 screws (4) behind weatherstrip.

Tighten the screws to 2 N.m (18 lb in).

4. Reposition the weatherstrip (3).