88. Crankshaft Balancer Installation

Crankshaft Balancer Installation


Special Tools
* EN-48034 Crankshaft Balancer Installer
* J 45059 Angle Meter






1. Install the friction washer on the back side of the crankshaft balancer.
2. Install the crankshaft balancer using EN-48034 .
3. Remove EN-48034 .
4. Hold the flywheel or back of the crankshaft. The crankshaft balancer does not have a keyway so the crankshaft could turn when tightening, causing an improper torque.





Notice: Refer to Fastener Notice .

5. Install the crankshaft balancer washer and new bolt.

1. Tighten the new crankshaft balancer bolt while holding the back to 150 N.m (110 lb ft).
2. Use J 45059 to tighten the crankshaft balancer bolt an additional 180 degrees.