C0306

DTC C0306

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (Diagnostic System Check - Vehicle) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (Strategy Based Diagnosis) for an overview of the diagnostic approach.
* Diagnostic Procedure Instructions (Diagnostic Procedure Instructions) provides an overview of each diagnostic category.



DTC Descriptor
DTC C0306
- Motor A or B Circuit Malfunction




Circuit/System Description

The transfer case motor is a bi-directional, permanent magnet, D.C. motor. When energized, through motor control A or motor control B, the ground is provided by the opposing motor control circuit and then grounded through the transfer case shift control module ground circuit, the motor, through a series of gears, rotates a shaft which moves the mode and range forks to shift the transfer case between the following ranges:

* 4HI
* 4HI Lock
* 4LO Lock
* Neutral


This DTC detects an open, short to voltage, or short to ground in the motor control A or motor control B circuits, or an open, or short to ground inside the motor.


Conditions for Running the DTC

* The ignition is ON.
* The system voltage is 9-18 volts.



Conditions for Setting the DTC

* The system will test the motor circuits by checking for unwanted voltage.
* Then, the system supplies voltage on each of the motor circuits and reads the voltage back on the other circuit.
* If the system detects a problem with the circuits, the DTC is logged. The transfer case shift control module senses a low voltage return in the motor control A or motor control B circuits when a high voltage is expected.
* The fault must remain current for 1.2 seconds to set the DTC.



Action Taken When the DTC Sets

* All shifting will be disabled.
* The SERVICE 4WD indicator will remain illuminated for the remainder of the current ignition cycle.



Conditions for Clearing the DTC

* The transfer case shift control module will clear the DTC if the condition for setting the DTC is not currently present.
* A history DTC will clear after 100 consecutive ignition cycles without a fault present.
* History DTCs can be cleared using a scan tool.



Reference Information
Schematic Reference

Transfer Case Control Schematics (Electrical Diagrams)
Connector End View Reference

Component Connector End Views (Component Connector End Views)
Description and Operation

Transfer Case Description and Operation (Description and Operation)
Electrical Information Reference

* Circuit Testing (Component Tests and General Diagnostics)
* Connector Repairs (Component Tests and General Diagnostics)
* Testing for Intermittent Conditions and Poor Connections (Component Tests and General Diagnostics)
* Wiring Repairs (Component Tests and General Diagnostics)

Scan Tool Reference

Control Module References (Programming and Relearning) for scan tool information.


Repair Instructions

Perform the Diagnostic Repair Verification (Verification Tests) after completing the diagnostic procedure.