Clutch Slave Cylinder: Service and Repair
Clutch Actuator Cylinder Replacement
Removal Procedure
1. Remove the transmission.
2. Remove the 2 clutch actuator cylinder bolts (3).
3. Remove the clutch actuator cylinder (1) from the input shaft bearing retainer (2).
Installation Procedure
1. Position the clutch actuator cylinder (1) to the input shaft bearing retainer (2).
Notice: Refer to Fastener Notice.
2. Install the 2 clutch actuator cylinder bolts (3).
Tighten the clutch actuator cylinder bolts to 8 N.m (71 lb in).
3. Install the transmission.