Rack and Pinion Outer Tie Rod End Replacement

Rack and Pinion Outer Tie Rod End Replacement

Tools Required

J 24319-B Steering Linkage and Tie Rod Puller

Removal Procedure

1. Raise and support the vehicle. refer to vehicle lifting.
2. Remove the tire and wheel.




3. Remove and discard the outer tie rod retaining nut.





Notice: Do not attempt to disconnect a steering linkage joint by driving a wedge between the joint and the attached part. Seal damage may result which will cause premature failure of the joint.

4. Disconnect the outer tie rod from the steering knuckle using J 24319-B.
5. Loosen the jam nut and remove the outer tie rod from the inner tie rod. Discard the jam nut.
6. Clean the tapered surface of the steering knuckle.

Installation Procedure

1. Lubricate the inner tie rod threads with a suitable chassis lubricant before installing the outer tie rod.
2. Install the new jam nut to the outer tie rod.
3. Install the outer tie rod to the inner tie rod.




4. Install the outer tie rod to the steering knuckle.

Notice: Refer to Fastener Notice.

5. Install the new outer tie rod retaining nut.

Tighten the outer tie rod retaining nut to 71 N.m (52 lb ft).

6. Install the tire and wheel.
7. Lower the vehicle.
8. Adjust the front toe. Refer to Front Toe Adjustment.