Transmission Position Sensor/Switch: Adjustments

Park/Neutral Backup Switch Adjustment

Important:
* The following procedure is for vehicles that have not had the switch removed or replaced. If the switch has been removed or replaced, refer to Park/Neutral Backup Switch Replacement for the proper adjustment procedure.

* Apply the parking brake.

* The engine must start in the P (PARK) or N (NEUTRAL) positions only.

* Check the switch for proper operation. If adjustment is required, proceed as follows:

1. Place the transmission range selector in the N (NEUTRAL) position.
2. With an assistant in the drivers seat, raise and support the vehicle. refer to vehicle lifting.
3. Loosen the park/neutral position switch mounting bolts.
4. With the vehicle in the N (NEUTRAL) position, rotate the switch while the assistant attempts to start the engine.
5. Following a successful start, turn the engine OFF.

Notice: Refer to Fastener Notice.

6. Tighten the bolts securing the park/neutral back up switch to the transmission.

Tighten the park/neutral back up switch bolts to 27 N.m (20 lb ft).

7. Lower the vehicle.
8. Check the switch for proper operation. The engine must start in the P (PARK) or N (NEUTRAL) positions only.
9. Replace the park/neutral position switch if proper operation can not be achieved.