Accelerator Pedal Position Sensor: Service and Repair

Accelerator Pedal Position Sensor Replacement

Removal Procedure




1. Remove the knee bolster bracket.
2. Disconnect the accelerator pedal position (APP) sensor electrical connector.




3. Remove the accelerator pedal/APP sensor nuts.
4. Remove the accelerator pedal/APP sensor from the vehicle.

Installation Procedure




1. Install the accelerator pedal/APP sensor over the studs.

Notice: Refer to Fastener Notice.

2. Install the accelerator pedal/APP sensor nuts.

Tighten the nuts to 9 N.m (80 lb in).




3. Connect the APP sensor electrical connector.
4. Inspect below the pedal for binding, to ensure full range of motion.
5. Install the knee bolster bracket.