Roof Identification Lamp Bulb Replacement

Roof Identification Lamp Bulb Replacement

Removal Procedure




1. Remove the 6 fastener covers (1) by inserting a flat-head screwdriver into the slot on the passenger's side of each cover and gently lifting upward.
2. Using a T25(R) torx driver, loosen the 6 bolts under the fastener covers.
3. Rotate lightbar back so that lightbar is laying upside down on roof. Remove the bulb socket from lamp assembly by rotating the bulb socket 1/4 turn counterclockwise.
4. Pull the bulb out of the socket.
5. Replace bulb.

Installation Procedure

1. Install the bulb socket into the lamp assembly by rotating the bulb socket 1/4 turn clockwise.

Notice: Refer to Fastener Notice.

2. Rotate lightbar to correct orientation and install the bolts using the T25 torx driver.

4.5 N.m (30 lb in).

3. Install the 6 fastener covers by aligning the tab to driver's side and gently pressing in place.