Door Ajar Indicator Malfunction

Door Ajar Indicator Malfunction

Diagnostic Fault Information

Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. Diagnostic System Check - Vehicle

Circuit/System Description

The body control module (BCM) receives an input from all four door ajar switches, drivers, passengers, left rear, and right rear. The door ajar switches are normally open when the doors are fully closed. When a door is opened, the door ajar switch contacts close providing a path to ground. The driver information center (DIC) on the instrument panel cluster (IPC), illuminates the door ajar message when the one of the doors is open. The IPC receives a serial data message from the BCM, indicating the door ajar status. If this message is displayed and the vehicle speed is greater than 8.1 km/h (5 mph), a chime will sound.

Circuit/System Testing

1. Ignition OFF, disconnect the harness connectors at the four door ajar switch assemblies.
2. Ignition OFF, test for less than 1.0 ohm of resistance between each of the four ground circuits and ground

• If any of the ground circuits are greater than 1.0 ohm, test that ground circuit for an open/high resistance.

3. Verify all the scan tool Door Ajar Switch parameters show Door Closed.

• If not Door Closed, test the appropriate signal circuit for a short to ground. If the circuits test normal, replace the BCM.

4. Install a 3-amp fused jumper one at a time between the four signal circuits and ground. Verify that each scan tool Door Ajar Switch parameter is Door Ajar when each signal circuit is jumpered.

• If not Door Ajar, test the appropriate signal circuit for a short to voltage or an open/high resistance. If all circuits test normal, replace the BCM.

5. Ignition OFF, reconnect the harness connectors at the four door ajar switch assemblies, one at a time. Open and close the door with the reconnected harness. Verify that each scan tool Door Ajar Switch parameter is Door Ajar when the door is open and Door Closed when the door is closed.

• If not Door Ajar when open or Door Closed when closed, replace the appropriate door ajar switch assembly.

6. If all circuits test normal, test or replace the IPC.

Repair Instructions

Perform the Diagnostic Repair Verification after completing the diagnostic procedure. Verification Tests

Refer to Programing and Relearning for BCM or IPC replacement, setup, and programming. Programming and Relearning