Parking Brake Warning Switch: Service and Repair

Park Brake Warning Lamp Switch Replacement

Removal Procedure




Caution: Refer to Battery Disconnect Caution.

1. Disconnect the negative battery cable.
2. Remove the MID-bussed electrical center from the bracket.
3. Disconnect the park brake warning lamp switch electrical connector.




4. Remove the park brake warning lamp switch mounting bolt.
5. Remove the park brake warning lamp switch.

Installation Procedure




1. Install the park brake warning lamp switch.

Notice: Refer to Fastener Notice.

2. Install the park brake warning lamp switch mounting bolt.

Tighten the bolt to 3 N.m (25 lb in).




3. Connect the park brake warning lamp switch electrical connector.
4. Install the MID-bussed electrical center to the bracket.
5. Connect the negative battery cable.