FREE REPAIR MANUALS & LABOR GUIDES 1982-2013 Vehicles
Courtesy of Operation CHARM: Car repair manuals for everyone.
Home >> Hummer >> 2007 >> H2 V8-6.0L >> Repair and Diagnosis >> Relays and Modules >> Relays and Modules - Powertrain Management >> Relays and Modules - Computers and Control Systems >> Electronic Throttle Control Module >> Service and Repair

Electronic Throttle Control Module: Service and Repair



Throttle Actuator Control Module Replacement

Removal Procedure




1. Remove the left hand corner brace from the cowl.
2. Remove the throttle actuator control (TAC) module mounting nuts.
3. Disconnect the TAC module electrical connectors from the TAC module.

Installation Procedure




1. Connect the TAC module electrical connectors to the TAC module.

Notice: Refer to Fastener Notice.

2. Install the TAC module onto the studs and install the mounting nuts.

Tighten the TAC mounting nuts to 9 N.m (80 lb in).

3. Install the left hand corner brace.

Tighten the corner brace bolts to 25 N.m (18 lb ft).

4. Refer to Control Module References for programming and setup information. Programming and Relearning

pro multis Credits:Operation CHARM About Operation CHARM