Park/Turn Signal Lamp Replacement (SUT Rear)

Park/Turn Signal Lamp Replacement (SUT Rear)

Removal Procedure




1. Release the lamp socket (1) from the lens.
2. From the exterior side of the end cap, insert a flat blade at the top side center of the lens.
3. Gently pry upward on the flat blade in order to release the clip (2).
4. Pull the top of the lens outward.
5. Lift the lens from the opening.

Installation Procedure






Important: Ensure the bottom edge is secured first.

1. Position the lamp housing to the end cap opening.
2. Press inward at the top of the lamp in order to secure the tab (3).




3. Position the lamp socket (1) into the lamp (2) and turn 1/4 in order to secure.