Clearance Lamp Replacement (SUT Rear)

Clearance Lamp Replacement (SUT Rear)

Removal Procedure




1. Remove the screw from the lamp.
2. Remove the lamp by lifting upward.
3. Disconnect the lamp socket.
4. Remove the lamp housing from the vehicle.
5. Remove the bulb, if needed.

Installation Procedure




1. Install the bulb to the socket.
2. Install the socket to the lamp housing.
3. Ensure the lamp housing foam seal is not damaged.
4. Install the lamp assembly to the roof luggage carrier side rail end cap.

Notice: Refer to Fastener Notice.

5. Install the screw to the lamp assembly.

Tighten the screw to 2.5 N.m (22 lb in).