Control Assembly: Service and Repair

HVAC Control Module Replacement

Removal Procedure




1. Remove the center instrument panel (I/P) trim bezel.
2. Remove the screws from the HVAC control module (2).
3. Depress the HVAC control module tabs (3) and remove the HVAC control module (2) from the I/P (4).
4. Reposition the HVAC control module (2) from the I/P panel (1).
5. Disconnect the electrical connectors from the HVAC control module (2).

Installation Procedure

Important: The Key should be in the off position when connecting the electrical connectors to ensure proper calibration.




1. Connect the electrical connectors to the HVAC control module (2).

Important: Ensure that the HVAC control module tabs lock into place.

2. Install the HVAC control module (2) to the I/P (1).

Notice: Refer to Fastener Notice.

3. Install the screws to the HVAC control module (2).

Tighten the screws to 1.9 N.m (17 lb in).

4. Install the center I/P trim bezel.

Important: Do not adjust any controls on the HVAC control module while the HVAC control module is calibrating.

If interrupted improper HVAC performance will result.

5. Start the vehicle and let run for one minute.