Mode Actuator Replacement

Mode Actuator Replacement

Removal Procedure




1. Remove the push pin (5) from the HVAC module assembly (1).
2. Remove the left floor duct (3) from the HVAC module assembly (1).




3. Disconnect the electrical connector (3) from the mode actuator (4).
4. Remove the screws from the mode actuator (4).
5. Remove the mode actuator (4) from the HVAC module assembly (1).
6. Remove the cam (2) from the HVAC module assembly (1).

Installation Procedure




1. Install the cam (2) to the HVAC module assembly (1).
2. Install the mode actuator (4) to the HVAC module assembly (1).

Notice: Refer to Fastener Notice.

3. Install the screws to the mode actuator (4).

Tighten the screws to 2 N.m (18 lb in).

4. Connect the electrical connector (3) to the mode actuator (4).




5. Install the left floor air outlet duct (3) to the HVAC module assembly (1).
6. Install the push pin (5) to the HVAC module assembly (1).
7. Reprogram the Right air temperature actuator. Refer to Re-Calibrating Actuators. Programming and Relearning