FREE REPAIR MANUALS & LABOR GUIDES 1982-2013 Vehicles
Courtesy of Operation CHARM: Car repair manuals for everyone.
Home >> Hummer >> 2007 >> H2 V8-6.0L >> Repair and Diagnosis >> Engine, Cooling and Exhaust >> Engine >> Intake Manifold >> Service and Repair >> Upper Intake Manifold Sight Shield Replacement (6.0L (LQ4))

Upper Intake Manifold Sight Shield Replacement (6.0L (LQ4))



Upper Intake Manifold Sight Shield Replacement (6.0L (LQ4))

Removal Procedure




1. Loosen the intake manifold sight shield bolt.
2. Remove the sight shield from the sight shield retainer.
3. Remove the sight shield retainer bolts and the retainer, if required.

Installation Procedure

Notice: Refer to Fastener Notice.

1. Install the sight shield retainer and the bolts, if required.

Tighten the retainer bolts to 5 N.m (44 lb in).





Notice: Use care when installing the engine sight shield to avoid contacting the manifold absolute pressure (MAP) sensor wire harness connector. Loss of engine performance or engine damage may result.

2. Install the intake manifold sight shield to the retainer.

Tighten the bolt to 10 N.m (89 lb in).

pro multis Credits:Operation CHARM About Operation CHARM