Valve Rocker Arm Cover Replacement - Left Side

Valve Rocker Arm Cover Replacement - Left Side

Removal Procedure




1. Remove the engine sight shield.
2. Remove the connector position assurance (CPA) lock.
3. Disconnect the main electrical connector (2) feeding the ignition coils.
4. Remove the harness clips (1).
5. Reposition the engine harness.
6. Remove the spark plug wires from the ignition coils.
^ Twist each plug wire 1/2 turn.
^ Pull only on the boot in order to remove the wire from the ignition coil.




7. Remove the ignition coil bracket studs from the rocker arm cover.
8. Remove the ignition coils and bracket from the rocker arm cover.
9. Remove the valve rocker arm cover bolts.
10. Remove the valve rocker arm cover.




11. Remove the gasket (1) from the rocker cover.
12. Discard the OLD gasket.
13. Clean and inspect the rocker arm cover.

Installation Procedure

Important:

* All gasket surfaces should be free of oil an/or other foreign material during assembly.

* DO NOT reuse the valve rocker arm cover gasket.

* The valve rocker arm cover bolt grommets may be reused.

* If the PCV valve grommet has been removed from the rocker cover, install a NEW grommet during assembly.




1. Install a NEW rocker cover gasket (1) into the valve rocker cover lip.
2. Install the valve rocker arm cover onto the cylinder head.
3. Install new rocker arm cover grommets, if necessary.

Notice: Refer to Fastener Notice.

4. Install the rocker arm cover bolts.

Tighten the bolts to 12 N.m (106 lb in).




5. Apply threadlock to the threads of the bracket bolts. Refer to Sealers, Adhesives, and Lubricants for the correct part number.
6. Install the ignition coils and bracket to the rocker arm cover.
7. Install the ignition coil bracket studs to the rocker arm cover.

Tighten the studs to 12 N.m (106 lb in).




8. Install the spark plug wires to the ignition coils.
9. Re-position the engine harness.
10. Install the harness clips (1).
11. Connect the main electrical connector (2) feeding the ignition coils.
12. Install the CPA lock.
13. Install the engine sight shield.